How to flash samsung galaxy tab 3 10.1 P5200 P5210 P5220 KitKat 4.4.4

GUIDE TO SAMSUNG GALAXY TAB 3 10.1 KITKAT  USING ODIN FLASHER

Important Things To Do Before Flashing Stock ROM:

      Before you can proceed to the process make sure that you do the things we will list below and that you read it carefully, this procedure works perfectly and tested by many users, so if you have doubt or questions about this post you can leave a comment below:

• Prepare your USB Cable, PC, STOCK ROM or Firmware Files (Download Below). 
• Flashing the Stock Firmware will delete your personal data from the device. If in case you are going to Flash the above firmware then take a backup of your personal data, so that you can recover your personal data if any thing wrong happens.
• Also doing this process is crucial so we admit you have a presence of mind, common sense, and read our disclaimer below, as well as make sure you have at least 60% to 80%.

Why Need Stock Firmware?

• Flashing Stock ROM will downgrade your phone if you don’t like the new update. 
• Flashing Stock ROM will Upgrade your phone. 
• Flashing Stock ROM will fix bootloop issues. 
• Flashing Stock ROM will completely Unroot . 
• Installing Stock ROM will Unbrick. 
• Flashing Stock ROM will help to Revert back to Original Stock ROM Firmware or Factory state (Helpful if you are facing force close error or any other lags or unstable internet connection).

Download Area:

• Tab 3 10.1 P5200 KitKat 4.4.2: From Here
• Tab 3 10.1 P5210 KitKat 4.4.4: From Here
• Tab 3 10.1 P5220 KitKat 4.4.4: From Here

Download Odin Flasher Odin3_v3.09.
Install Samsung Kies for install latest samsung drivers from here.

Fellow Video Tutorial How To Flash?

⧭⧭⧭⧭⧭⧭

How to Flash Samsung Galaxy Tab 3:

Step 1: Download the Odin software and the tab 3 firmware for your set , See downloads section above. 

Step 2: Extract Android firmware file.

Step 3: Extract Odin file.

Step 4: Switch off your Galaxy Tab 3 from PC, boot it into download mode. To achieve this, wait for six to seven seconds after screen goes off, and long press Volume Down + Power + Home buttons until warning screen is displayed. Then press, Volume Up to proceed to download mode.

Step 5: Interface your phone to PC using USB cable. In Odin you should see an "Added" message appearing in the Log box at the bottom left, and the first box under ID:COM will also change its background colour to Blue.

Step 6: Load firmware into Odin. To achieve this, Click on the AP button on Odin and the select the .tar.md5 extracted file as explained in Step 3.

Step 7: Within Odin, check to ensure that Re-partition checkbox is deselected,

Step 8: Within Odin, select Start Button to start flashing the firmware on your tablet.

Step 9: After completion of installation, your Galaxy tab will reboot automatically. You'll get a "Pass" message upon successful installation from Odin.

Step 10: Disconnect your tablet from the computer. Navigate to Settings > About Device to verify installation of new firmware.