How To Flash Samsung Star 3 Duos S5222 Tested Free Firmware (arabic)

How To Flash Samsung Star 3 Duos S5222 Tested Free Firmware (arabic)

You need this firmware/stock rom if you have encountered this kind of problem in your Smartphone Listed Below:
  • Hang on logo.
  • Rebooting.
  • Bootloop & Dead boot after a wrong software.
  • System crashing.

How to know if the phone had a hard problem (Emmc problem)??
  • What is Emmc problem? also called read mode only,  it means that your internal memory doesnt accept command, so the phone stay on the same condition after a software or a hard reset.
  • If the phone hang on logo after flash, you ara facing Emmc problem.
  • As a precaution you shouldn't change setting in SP flashtool from Download only to format+download, you will end with a dead phone if you have a Emmc problem ofcourse.

  • An original Samsung mobile usb cable.
  • Phone must be fully charged
  • Install Samsung kies Air to install drivers
  • Backup your phone data using Kies Air

Download Area:
Samsung star 3 Duos S5222 (S5222JPLC3) Arabic Firmware: From Here
Flash tool E2: From Here.
Samsung drivers (istall kies air): From Here.

Procedure to flash Samsung Star 3 Duos:
Step 1: Install necessary driver from flashtool folder (for 86bits or 64bits)

Step 2: Now it's time to run the flash tool, double click on flashtool E2.exe and run with admin permission.

Step 3: Click on 3 dots (...) button

Step 4:  Select the flash files one by one
Note The selecting of firmware files must be in the below order
1-psi.fls 2-slb.fls 3-BSY.fls 4-CDS.fls 5-CSC.dffs.

Step 5: Don't change any setting, just keep them as default.
Step 6: Click on next button when you click on next button A new window will appear.

Step 7: Click on start Usb 1 button

Step 8: Now Connect your phone to pc using Usb cable.
download mode trick: remove battery, insert usb, then rapidly reinsret battery, phone will be detected by the flashtool.
Step 9: The flashing process will start automatically,it will take 3 to 5 minutes to complete, depend on phone you are flashing.

Step 10: When the flashing process is done,a success message will be shown.

Step 11: Disconnect your phone, remove the usb cable & battery, then reinstall battery & power phone on.
All Done.