Guide To Flash Samsung Galaxy Tab 4 7.0 (LTE) SM-T235
Mobile : Galaxy Tab 4 7.0 LTE
Mobile : Galaxy Tab 4 7.0 LTE
Model : SM-T235
System Version : Lollipop 5.1.1
Baseband : NEE T235XXU1BOH7
System Version : Lollipop 5.1.1
Baseband : NEE T235XXU1BOH7
download link:
Download odin flasher:
Install Smart Switch for install latest samsung drivers from here.
Fellow Video Tutorial:
⧭⧭⧭⧭⧭
How to update Galaxy TAB 4 7.0 SM-T235 (LTE) to Android 5.1.1
Step 1: Download the Odin software and Android 5.1.1 firmware, from the downloads section above.
Step 2: Extract Android 5.1.1 firmware file.
Step 3: Extract Odin file.
Step 4: Switch off your Galaxy Tab 4 from PC, boot it into download mode. To achieve this, wait for six to seven seconds after screen goes off, and long press Volume Down + Power + Home buttons until warning screen is displayed. Then press, Volume Up to proceed to download mode.
Step 5: Interface your tablet to PC using USB cable. In Odin you should see an "Added" message appearing in the Log box at the bottom left, and the first box under ID:COM will also change its background colour to Blue.
Step 6: Load firmware into Odin. To achieve this, Click on the AP button on Odin and the select the .tar.md5 extracted file as explained in Step 3.
Step 7: Within Odin, check to ensure that Re-partition checkbox is deselected,
Step 8: Within Odin, select Start Button to start flashing the firmware on your tablet.
Step 9: After completion of installation, your Galaxy Tab 4 will reboot automatically. You'll get a "Pass" message upon successful installation from Odin.
Step 10: Disconnect your tablet from the computer. Navigate to Settings > About Device to verify installation of new firmware.
Step 2: Extract Android 5.1.1 firmware file.
Step 3: Extract Odin file.
Step 4: Switch off your Galaxy Tab 4 from PC, boot it into download mode. To achieve this, wait for six to seven seconds after screen goes off, and long press Volume Down + Power + Home buttons until warning screen is displayed. Then press, Volume Up to proceed to download mode.
Step 5: Interface your tablet to PC using USB cable. In Odin you should see an "Added" message appearing in the Log box at the bottom left, and the first box under ID:COM will also change its background colour to Blue.
Step 6: Load firmware into Odin. To achieve this, Click on the AP button on Odin and the select the .tar.md5 extracted file as explained in Step 3.
Step 7: Within Odin, check to ensure that Re-partition checkbox is deselected,
Step 8: Within Odin, select Start Button to start flashing the firmware on your tablet.
Step 9: After completion of installation, your Galaxy Tab 4 will reboot automatically. You'll get a "Pass" message upon successful installation from Odin.
Step 10: Disconnect your tablet from the computer. Navigate to Settings > About Device to verify installation of new firmware.